Search results
Results From The WOW.Com Content Network
In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist. Sources of such hazards include gases, vapors, dust, fibers, and flyings, which are combustible or flammable. Electrical equipment installed in such locations can provide an ignition source, due to ...
ATEX Directive 2014/34/EU was published on 29 March 2014, by the European Parliament. It refers to the harmonization of the laws of the Member States relating to equipment and protective systems intended for use in potentially explosive atmospheres. Regarding ATEX 99/92/EC Directive, the requirement is that Employers must classify areas where ...
HAZMAT Class 3 Flammable liquids. A flammable liquid is a liquid with flash point of not more than 60.5 °C (141 °F), or any material in a liquid phase with a flash point at or above 37.8 °C (100 °F) that is intentionally heated and offered for transportation or transported at or above its flash point in a bulk packaging.
NFPA 704 safety squares on containers of ethyl alcohol and acetone. " NFPA 704: Standard System for the Identification of the Hazards of Materials for Emergency Response " is a standard maintained by the U.S. -based National Fire Protection Association. First "tentatively adopted as a guide" in 1960, [1] and revised several times since then, it ...
Intrinsic safety ( IS) is a protection technique for safe operation of electrical equipment in hazardous areas by limiting the energy, electrical and thermal, available for ignition. In signal and control circuits that can operate with low currents and voltages, the intrinsic safety approach simplifies circuits and reduces installation cost ...
Cold drop ( Spanish: gota fría; archaic as a meteorological term), colloquially, any high impact rainfall event along the Mediterranean coast of Spain. Drought, a prolonged water supply shortage, often caused by persistent lack of, or much reduced, rainfall. Floods. Flash flood. Rainstorm. Red rain in Kerala (for related phenomena, see Blood rain)
IP code. The IP code or ingress protection code indicates how well a device is protected against water and dust. It is defined by the International Electrotechnical Commission (IEC) under the international standard IEC 60529 [ 1] which classifies and provides a guideline to the degree of protection provided by mechanical casings and electrical ...
Certified and labelled for use in areas with specific hazardous conditions: for indoor and outdoor use in locations classified as Class II, Groups E, F, or G as defined in NFPA standards such as the NEC. 10: MSHA. Meets the requirements of the Mine Safety and Health Administration, 30 CFR Part 18 (1978). 11: General-purpose.