Search results
Results From The WOW.Com Content Network
A tower type UPS with one IEC 60320 C14 input and three C13 outlets. A large data-center-scale UPS being installed by electricians. An uninterruptible power supply ( UPS) or uninterruptible power source is a type of continual power system that provides automated backup electric power to a load when the input power source or mains power fails.
A shunt charge controller or shunt regulator diverts excess electricity to an auxiliary or "shunt" load, such as an electric water heater, when batteries are full. [7] Simple charge controllers stop charging a battery when they exceed a set high voltage level, and re-enable charging when battery voltage drops back below that level.
Automatic gain control. Schematic of an AGC used in the analog telephone network; the feedback from output level to gain is effected via a Vactrol resistive opto-isolator. Automatic gain control ( AGC) is a closed-loop feedback regulating circuit in an amplifier or chain of amplifiers, the purpose of which is to maintain a suitable signal ...
Charge carrier density. Charge carrier density, also known as carrier concentration, denotes the number of charge carriers per volume. In SI units, it is measured in m −3. As with any density, in principle it can depend on position. However, usually carrier concentration is given as a single number, and represents the average carrier density ...
Rep. Gregory Meeks (D-N.Y.) on Tuesday said he believes the candidacy of Vice President Harris will drive Black voter excitement to levels higher than what was seen in 2008, when former President ...
Craig Monroe started working as a Tigers analyst in 2012 and is their lead analyst with Bally Sports Detroit this season. (Mitchell Layton/Getty Images) (Mitchell Layton via Getty Images)
Ben Hasty. A boil water advisory is in place for the East Bank of New Orleans and Algiers Point after a foil balloon hit a power line and briefly caused an outage at a water treatment plant ...
Pre-charge. Peak inrush current into a high voltage capacitor upon power up can stress the component, reducing its reliability. Pre-charge of the powerline voltages in a high voltage DC application is a preliminary mode which limits the inrush current during the power up procedure. A high-voltage system with a large capacitive load can be ...