Search results
Results From The WOW.Com Content Network
A switched-mode power supply ( SMPS ), also called switching-mode power supply, switch-mode power supply, switched power supply, or simply switcher, is an electronic power supply that incorporates a switching regulator to convert electrical power efficiently. Like other power supplies, an SMPS transfers power from a DC or AC source (often mains ...
Voltage regulation. In electrical engineering, particularly power engineering, voltage regulation is a measure of change in the voltage magnitude between the sending and receiving end of a component, such as a transmission or distribution line. Voltage regulation describes the ability of a system to provide near constant voltage over a wide ...
A regulated power supply is an embedded circuit; it converts unregulated AC (alternating current) into a constant DC. With the help of a rectifier it converts AC supply into DC. Its function is to supply a stable voltage (or less often current), to a circuit or device that must be operated within certain power supply limits.
Three-phase transformer with four-wire output for 208Y/120 volt service: one wire for neutral, others for A, B and C phases. Three-phase electric power (abbreviated 3ϕ [1]) is a common type of alternating current (AC) used in electricity generation, transmission, and distribution. [2] It is a type of polyphase system employing three wires (or ...
Power supply. A simple general-purpose desktop power supply used in electronic labs, with power output connector seen at lower-left and power input connector (not shown) located at the rear. Interior of high-end linear power supply with toroidal mains transformer. A power supply is an electrical device that supplies electric power to an ...
A tower type UPS with one IEC 60320 C14 input and three C13 outlets. A large data-center-scale UPS being installed by electricians. An uninterruptible power supply ( UPS) or uninterruptible power source is a type of continual power system that provides automated backup electric power to a load when the input power source or mains power fails.
Electrical equipment may be designed with a floating ground for one of several reasons. One is safety. For example, a low-voltage DC power supply, such as a mobile phone charger, is connected to the mains through a transformer of one type or another, and there is no direct electrical connection between the current return path on the low-voltage side and physical ground (earth).
Power supply rejection ratio. In electronic systems, power supply rejection ratio ( PSRR ), also supply-voltage rejection ratio [1] ( kSVR; SVR ), is a term widely used to describe the capability of an electronic circuit to suppress any power supply variations to its output signal. In the specifications of operational amplifiers, the PSRR is ...