Search results
Results From The WOW.Com Content Network
Metric drill bit sizes. Metric drill set, 1.0–6.0 mm by 0.1 mm, jobber length. The case that holds them in an indexed order (by size), via a graduated series of holes, is called a drill index. Metric drill bit sizes define the diameter of the bit in terms of standard metric lengths. Standards organizations define sets of sizes that are ...
Schematic of a machine tap. Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter.. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.
Drill bit (upper left), mounted on a pistol-grip electric drill. A set of masonry drills. A drill bit is a cutting tool used in a drill to remove material to create holes, almost always of circular cross-section. Drill bits come in many sizes and shapes and can create different kinds of holes in many different materials.
A 4.2-inch mortar in Korea, 1952. The M2 4.2-inch mortar was a U.S. rifled 4.2-inch (107 mm) mortar used during the Second World War, the Korean War, and the Vietnam War. It entered service in 1943. It was nicknamed the "Goon Gun" (from its large bullet-shaped shells, monopod, and rifled bore) or the "Four-Deuce" (from its bore size in inches).
Drill bit shank. The shank is the end of a drill bit grasped by the chuck of a drill. The cutting edges of the drill bit contact the workpiece, and are connected via the shaft with the shank, which fits into the chuck. In many cases a general-purpose arrangement is used, such as a bit with cylindrical shaft and shank in a three-jaw chuck which ...
Roller cone bit. A roller-cone bit is a drill bit used for drilling through rock that features 2 or 3 abrasive, spinning cones that break up rock and sediment as they grind against it. Roller-cone bits are typically used when drilling for oil and gas. [1] A water jet flowing through the bit washes out the rock in a slurry.
The pilot hole also reduces the power needed to turn a large drill bit, and reduces the large bit breakage risk. For twist drill bits, the pilot size is usually selected so that the chisel point of the larger drill does not need to remove any material, which reduces the chance of splitting the web of the bit. A pilot thus sized also prevents a ...
A tap is used to cut or form the female portion of the mating pair (e.g. a nut ). A die is used to cut or form the male portion of the mating pair (e.g. a bolt ). The process of cutting or forming threads using a tap is called tapping, whereas the process using a die is called threading . Both tools can be used to clean up a thread, which is ...