NetFind Web Search

  1. Ads

    related to: 2 channel amp wiring

Search results

  1. Results From The WOW.Com Content Network
  2. Bridged and paralleled amplifiers - Wikipedia

    en.wikipedia.org/wiki/Bridged_and_paralleled...

    A bridge-parallel amplifier topology is a hierarchical combination of the bridged and paralleled amplifier topologies, with at least four single-ended channels needed to produce one bridge-parallel channel. The two topologies complement each other in that the bridging allows for higher voltage output and the paralleling provides the current ...

  3. Bi-amping and tri-amping - Wikipedia

    en.wikipedia.org/wiki/Bi-amping_and_tri-amping

    Bi-amping - An active crossover with two amplifiers. Bi-amping and tri-amping is the practice of using two or three audio amplifiers respectively to amplify different audio frequency ranges, with the amplified signals being routed to different speaker drivers, such as woofers, subwoofers and tweeters. With bi-amping and tri-amping, an audio ...

  4. Balanced audio - Wikipedia

    en.wikipedia.org/wiki/Balanced_audio

    Balanced audio is a method of interconnecting audio equipment using balanced interfaces. This type of connection is very important in sound recording and production because it allows the use of long cables while reducing susceptibility to external noise caused by electromagnetic interference. The balanced interface guarantees that induced noise ...

  5. Jim Kelley Amplifiers - Wikipedia

    en.wikipedia.org/wiki/Jim_Kelley_Amplifiers

    Jim Kelley Amplifiers is the trademark for the vacuum tube guitar amplifiers designed by Jim Kelley and manufactured by his company Active Guitar Electronics of Tustin, California between the years of 1978 and 1985. [1] Approximately 600 of these amps were built during that time. [2] The single-channel version of the amplifier employed modest ...

  6. Category 6 cable - Wikipedia

    en.wikipedia.org/wiki/Category_6_cable

    Category 6 cable ( Cat 6) is a standardized twisted pair cable for Ethernet and other network physical layers that is backward compatible with the Category 5/5e and Category 3 cable standards. Cat 6 must meet more stringent specifications for crosstalk and system noise than Cat 5 and Cat 5e. The cable standard specifies performance of up to 250 ...

  7. RCA connector - Wikipedia

    en.wikipedia.org/wiki/RCA_connector

    The RCA connector [3] is a type of electrical connector commonly used to carry audio and video signals. The name RCA derives from the company Radio Corporation of America, which introduced the design in the 1930s. [4] The connector’s male plug and female jack are called RCA plug and RCA jack . It is also called RCA phono connector [5] or ...