Ads
related to: 2 channel amp wiring diagram
Search results
Results From The WOW.Com Content Network
Bridged or paralleled modes of working, normally involving audio power amplifiers, are methods of using a two or more identical amplifiers to drive the same load simultaneously. This is possible for sets of mono, stereo and multichannel amplifiers since the amplifier outputs are combined on a per load basis. Depending on the method of combining ...
Bi-amping - An active crossover with two amplifiers. Bi-amping and tri-amping is the practice of using two or three audio amplifiers respectively to amplify different audio frequency ranges, with the amplified signals being routed to different speaker drivers, such as woofers, subwoofers and tweeters. With bi-amping and tri-amping, an audio ...
XLR3 cable connectors female (left) and male. The XLR connector is a type of electrical connector primarily used in professional audio, video, and stage lighting equipment. XLR connectors are cylindrical, with three to seven connector pins, and are often employed for analog balanced audio interconnections, AES3 digital audio, portable intercom, DMX512 lighting control, and for low-voltage ...
Hafler circuit. The Hafler circuit is a passive electronics circuit with the aim of getting derived surround sound or ambiophony from regular stereo recordings without using costly electronics. Such circuits are generally known as matrix decoders.
Typically 0–100 MHz. The RCA connector [3] is a type of electrical connector commonly used to carry audio and video signals. The name RCA derives from the company Radio Corporation of America, which introduced the design in the 1930s. [4] The connector’s male plug and female jack are called RCA plug and RCA jack .
Four-position, four-contact (4P4C) plug, used for connecting a telephone handset and base. Six-position, six-contact (6P6C) jack, which could be wired as RJ11, RJ14, or RJ25. A registered jack ( RJ) is a standardized telecommunication network interface for connecting voice and data equipment to a computer service provided by a local exchange ...
Category 6 cable ( Cat 6) is a standardized twisted pair cable for Ethernet and other network physical layers that is backward compatible with the Category 5/5e and Category 3 cable standards. Cat 6 must meet more stringent specifications for crosstalk and system noise than Cat 5 and Cat 5e. The cable standard specifies performance of up to 250 ...
Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems. Normally, there is one pair of connectors on a loudspeaker and a single cable (two conductors) runs from the amplifier output to the terminals at the loudspeaker housing. From this point, connections are made to the loudspeaker drivers ...