NetFind Web Search

  1. Ads

    related to: charging motorcycle battery at 2 amps calculator

Search results

  1. Results From The WOW.Com Content Network
  2. Float voltage - Wikipedia

    en.wikipedia.org/wiki/Float_voltage

    Float voltage is the voltage at which a battery is maintained after being fully charged to maintain that capacity by compensating for self-discharge of the battery. [1] The voltage could be held constant for the entire duration of the cell's operation (such as in an automotive battery) or could be held for a particular phase of charging by the charger. [2]

  3. Trickle charging - Wikipedia

    en.wikipedia.org/wiki/Trickle_charging

    Trickle charging means charging a fully charged battery at a rate equal to its self-discharge rate, thus enabling the battery to remain at its fully charged level; this state occurs almost exclusively when the battery is not loaded, as trickle charging will not keep a battery charged if current is being drawn by a load. [ 1][ 2] A battery under ...

  4. Depth of discharge - Wikipedia

    en.wikipedia.org/wiki/Depth_of_discharge

    the fraction of the battery's capacity which is currently removed from the battery with regard to its (fully) charged state. For fully charged batteries, the depth of discharge is connected to the state of charge by the simple formula. D o D = 1 − S o C {\displaystyle \mathrm {DoD} =1-\mathrm {SoC} } The depth of discharge then is the ...

  5. Capacitor discharge ignition - Wikipedia

    en.wikipedia.org/wiki/Capacitor_discharge_ignition

    Capacitor discharge ignition ( CDI) or thyristor ignition is a type of automotive electronic ignition system which is widely used in outboard motors, motorcycles, lawn mowers, chainsaws, small engines, turbine -powered aircraft, and some cars. It was originally developed to overcome the long charging times associated with high inductance coils ...

  6. Inrush current - Wikipedia

    en.wikipedia.org/wiki/Inrush_current

    Inrush current. Inrush current, input surge current, or switch-on surge is the maximal instantaneous input current drawn by an electrical device when first turned on. Alternating-current electric motors and transformers may draw several times their normal full-load current when first energized, for a few cycles of the input waveform.

  7. Power-to-weight ratio - Wikipedia

    en.wikipedia.org/wiki/Power-to-weight_ratio

    Power-to-weight ratio is a measurement of actual performance of any engine or power source. It is also used as a measurement of performance of a vehicle as a whole, with the engine's power output being divided by the weight (or mass) of the vehicle, to give a metric that is independent of the vehicle's size. Power-to-weight is often quoted by ...

  8. Deep-cycle battery - Wikipedia

    en.wikipedia.org/wiki/Deep-cycle_battery

    A deep cycle battery powering a traffic signal. A deep-cycle battery is a battery designed to be regularly deeply discharged using most of its capacity. The term is traditionally mainly used for lead–acid batteries in the same form factor as automotive batteries; and contrasted with starter or 'cranking' automotive batteries designed to deliver only a small part of their capacity in a short ...

  9. Battery charger - Wikipedia

    en.wikipedia.org/wiki/Battery_charger

    A mobile phone plugged in to an AC adapter for charging. A battery charger, recharger, or simply charger, [ 1][ 2] is a device that stores energy in an electric battery by running current through it. The charging protocol—how much voltage, current, for how long and what to do when charging is complete—depends on the size and type of the ...